Scheme 1
see 9814115
Scheme 2
Note. When lifting the vehicle, use the green-marked lifting points in the illustration. The lifting plate shall be provided with rubber so that the vehicle is not damaged.
Scheme 3
Explanation of symbols
- As measured from center
- As measured from one edge
- Measurement is indicated from a cut marking
Scheme 4
As measured from the bottom of the recess. If only one measurement point symbol is shown, it applies to both points. Otherwise, the symbols appear on each side of the measurement designation in the illustration.
Scheme 5
Scheme 6
The dimensions in the table are listed as follows
Symbol number 1 means that the measurement is taken from the center.
Symbol number 2 means that the measurement is taken from an edge.
Scheme 7
Symbol number 3 means that you measure from a cut marking. Measurement takes place from the bottom of the recess. See illustration. If only one measuring point symbol is shown it applies to both measuring points. Otherwise the symbols are shown on one side each of the measurement designation in the illustration.
