Home/Volvo/V70/Volvo V70 II (2000-2004)/Repair manual/Gearbox, Input/output Speed Sensor - Removal & Installation/Software

Contents

Wiring diagrams Section: Gearbox, Input/output Speed Sensor - Removal & Installation

Gearbox, removing (Preparatory work)

Disconnecting the battery lead

Gearbox, removing (AW50/51 AWD; AW55-50/51SN; 2003-2007)

Gearbox, removing (M56; 2001-2007)

Gearbox, removing

Removing the hose

Measuring the position of the tie rod in the steering gear

Exposing the steering shaft joint

Removing the cap for the drive shaft support bearing

Installing the gearbox (AW50/51 AWD; B5234T3, AW55-50/51SN; 2001-2004)

Installing the angle gear

Installing the collision protection system over the steering gear

Installing the water hose

Installing the battery cable

Check

Installing the gearbox (AW50/51 AWD; AW55-50/51SN; 2001)

Installing the gearbox

Lifting the engine/gearbox

Installing the rear engine mounting

Installing the lower oil pipe to the gearbox

Installing the left-hand drive shaft to the gearbox and the wheel spindle

Fitting the subframe to the body

Installing the right-hand drive shaft to the gearbox, wheel spindle and link arm

Installing the steering wheel shaft joint

Installing the crossmembers

Installing the cable conduit

Removing the lifting beam

Fitting the remaining screws to the gearbox/starter motor

Installing the gear selector cables and oil line

Installing service clips

Installing engine compartment components

Installing the collision protection system over the steering gear (right-hand drive cars)

Lifting the engine and gearbox to the horizontal position

Installing the subframe on the bodywork

Installing the sealing ring for the CV joint housing

Installing the left drive shaft on the gearbox, stub axle and control arm

Installing the screws for the front engine pad

Installing the right drive shaft on the gearbox, stub axle and control arm

Installing new lock nuts on the steering gear

Lowering the car and removing the lifting beam and lifting tools from the engine

Installing the coolant hose

Installing the gearbox (TCM-002E, AW55-50/51SN; AW50/51 AWD; AW55-50/51SN; 2001-2007)

Fitting the sub-frame to the body

Installing the service clips

Installing the gearbox (B5254T4, TF-80SC AWD; 2006-2007)

Installing the left drive shaft on the transmission and the wheel spindle

Software

Jacking points, body

Installing the charge air pipe (only applies to 6-cylinder turbocharged engines)

Gear-shift position sensor, checking/adjusting

Gear-shift position sensor, checking/adjusting (AW50/51 AWD; AW55-50/51SN; 2001-2007)

Installing the gear selector cable

Input speed sensor/output speed sensor, replacing

Preparations

Installing the sensor

Installing the air cleaner (ACL) housing

Input speed sensor/output speed sensor, replacing (AW50/51 AWD; AW55-50/51SN; 2003-2007)

Information about the CAN network, structure and function

Joining cables

Disconnect the battery

Treat the cable terminal surfaces

Installing wheels (B5234T3; B5244S; B5244T3; 2001-2007)

All sections

Software Volvo V70 II

Gearbox, Input/output Speed Sensor - Removal & Installation

Software

Order and download software acc. to: 8645432