Final check Volvo V70 II

Final check

Check and top up if required

1. coolant level
2. the servo fluid level.

Test drive the engine.

Remove

1. the intake manifold between the electronic throttle module (ETM) and air cleaner (ACL) cover
2. the air cleaner (ACL) cover. Place it to one side
3. the camshaft position (CMP) sensor housing and the trigger wheel.

Scheme 28

Pull out the seal. Use puller 9995919 .

To clean the shaft journal and mating surface, use emery cloth P/N 951 1024.

Note. When cleaning work around the shaft journal, not in and out. It is essential that any residue from the emery cloth and any other contaminants are completely removed before the new sealing ring is installed.

Lubricate the surface of the seal that the camshaft rotates against. Install the camshaft seal. Use drift 9995450 .

Note. The seal is normally positioned at the same level as the internally bevelled edge. If the shaft journal is showing signs of wear, the seal can be pressed in a further 2 mm : Turn the drift socket.

For tightening torques, see: Tightening torque .

Install

1. the trigger wheel. Tighten the screw
2. the camshaft position (CMP) sensor housing. Tighten the screws
3. the air cleaner (ACL) cover
4. the intake manifold between the electronic throttle module and the air cleaner (ACL) cover.

Final check

Test drive the engine.