Installing the flywheel
Note. Ensure that the mating surfaces on the crankshaft and flywheel are completely clean.
Use tool 9995678 , consisting of 3 studs with nuts.
Install
- The 3 studs belonging to tool «9995678»(ref-403953-S14391401472011061000000) distributed as illustrated
- the flywheel.
Note. Check that the locating pin on the crankshaft is positioned opposite the hole in the flywheel.
Note. Only applies to cars with dual mass flywheels: There is a marking in the form of a shallow hole (see the arrow). The marking indicates the direction to the guide hole on the flywheel.
Fit the gear sector 9995112 against the flywheel.
Tighten in the flywheel against the crankshaft, alternate between nuts when tightening. Use the 3 nuts that belong to tool 9995678 .
| CAUTION | The flywheel must lie against the crankshaft flange before the screws are installed. There is a risk that excess locking fluid on the screws will come between the mating surfaces. |
Install 7 new screws. Tighten crosswise with 45 Nm .
Remove the 3 nuts and studs.
Install the remaining 3 new screws for the flywheel and tighten with 45 Nm . Then angle-tighten all 10 screws crosswise 65°.
Install the impulse sensor with bracket. Tighten with 10 Nm .
Install
- clutch. «Pressure plate/clutch driven plate, replacing»(ref-407119-S02573443282011070100000)
- transmission. «Transmission, installation»(ref-406844-S06757085912011070100000)
See Crankshaft seal rear, replacing
See Crankshaft seal, front, replacing
See Flywheel
See Crankshaft seal rear, replacing
See Crankshaft seal, front, replacing