Home/Volvo/V70/Volvo V70 II (2000-2004)/Repair manual/Engine - Overhaul Instructions (Xc)/Removing tappets

Contents

Wiring diagrams Section: Engine - Overhaul Instructions (Xc)

Cleaning

Selecting bearings

Removing the screwed joint from the intermediate section

Removing the piston cooling valve and nozzles

Classification of main bearings

The intermediate section

Marking the connecting rod (where applicable)

Installing the pistons in the cylinder bores

Installing the oil pump suction pipe

Installing the oil pan

Installing the oil cooler

Installing the rear crankshaft seal

New connecting rod

Checking the connecting rod in a connecting rod aligner

Installing the piston cooling valve and nozzles

Applying liquid gasket

Installing piston rings

Installing the sump

Removing the suction pipe from the oil pump

Checking markings

Removing the pistons from the cylinder block

Measuring the cylinder bore

Classification marking

Cylinder block, measurement

Installing the cylinder head

Installing tappets and camshafts

Measuring and reconditioning the cylinder head

Removing the cylinder head

Removing tappets

Removing valves

Removing valve stem seals

Checking the cylinder head

Checking for wear in the valve guides

Installing valve stem seals

Installing the valve / valve springs

Cylinder head, installing

Aligning the crankshaft

Installing valve lifters and camshafts

Installing the rear camshaft seal

Securing the camshafts

Cylinder head, removing

Removing the camshaft cover

Engine block, installing components

Installing engine block components

Crankshaft seal rear, replacing

Installing the sealing ring

Installing the gearbox

Engine body, exposing

Removing the gearbox

Pressure plate / clutch driven plate, replacing

Sealing micro-enclosed screws

Installing front crankshaft seal

Installing the timing gear pulley for the camshafts

Finishing

Checking the markings and belt tension

Oil pump / crankshaft seal, front, replacing

Belt drive, dismantling

Removing the oil pump

Removing the thermostat and thermostat housing

Installing the water pump

Installing the crankshaft timing gear pulley

Dismantling the belt transmission

Aligning the engine according to the marking

Removing the crankshaft pulley

Removing the belt tensioner and idler pulley

Removing the coolant pump / timing belt cover

Checking the opening function of the thermostat

Caulking

All sections

Removing tappets Volvo V70 II

Engine - Overhaul Instructions (Xc)

Removing tappets

Note. Magnets must not be used when lifting out the tappets.

Lift out the tappets. Mark up the tappets so that the original positions can be established.

Use a suction cup to remove the tappets.

Check for wear on the tappets.