Front panel, replacing
Removal
- Release the catches. Pull off the panel.
- The panel has double-sided adhesive tape. Ensure that any remains of the tape are removed from the black panel.
Installation
- Remove the backing from the tape on the panel and press the panel into place.
Order software according to the table below.
| V70 2001 | 9494717 |
After replacing the control module, the following must be carried out.
- Reprogram the customer programmed data.
- Carry out self-adjustment of the damper motor end positions.
- Test drive the car. Check that the function of the climate control system is OK.
- Then check that no diagnostic trouble codes have been stored during the replacement.
Information about programming the control module, damper motor self-adjustment and reading off diagnostic trouble codes can be found under VIDA vehicle communication information.
Scheme 235
Remove
- the switches. See Replacing climate control unit switches.
The information below applies to cars manufactured up to week 38 2001 inclusive.
Information for cars manufactured from week 39 2001 inclusive. See Control module engine coolant heater, replacing.