Home/Volvo/C70/Volvo C70 I (1997-2005)/Repair manual/Gear Shift Position Sensor, Solenoid Control System - Removal & Installation (Coupe)
Manual sections Wiring diagrams
Repair manual

Gear Shift Position Sensor, Solenoid Control System - Removal & Installation (Coupe) Volvo C70 I

Step-by-step instructions on "Gear Shift Position Sensor, Solenoid Control System - Removal & Installation (Coupe)" for Volvo C70 I (1997–2005). Pick an article — removal, installation, adjustment and diagnostics with illustrations.

67subsections
67articles
85illustrations

Preparations

1 article

Connect the connector to the transmission

1 article

Install the transmission cable on the transmission

1 article

Install the air cleaner (ACL) housing

1 article

Removing the gear-shift position sensor V70 2000- Model years 2000 and 2001

1 article

Removing the transmission cable

1 article

Removing the connector from the transmission

1 article

Installing the connector on the transmission

1 article

Adjusting the gear-shift position sensor

1 article

Installing the gear-shift position sensor, continued

1 article

Installing the gear selector cable

1 article

Installing engine compartment components

1 article

Removing engine compartment components

1 article

Installing the gear-shift position sensor

1 article

Removing the air cleaner (ACL) housing

1 article

Removing the gear selector cable and connector

1 article

Removing the gear-shift position sensor

1 article

Installing the lever and the gear-shift position sensor

1 article

Installing the air cleaner (ACL) housing

1 article

Replacing the gear-shift position sensor

1 article

Preparations for removing the center console

1 article

Install the parking brake lever

1 article

Install the center console

1 article

Pinion Seal for Bevel Gear, Replacing

1 article

Removing the three-way catalytic converter (TWC)

1 article

Installing the three-way catalytic converter (TWC)

1 article

Replacing the Primary Shaft Seal

1 article

Primary Shaft Seal

1 article

Primary Shaft Seal 41 mm

1 article

Primary shaft seal 44.6 mm

1 article

Replacing the Right Drive Shaft Pilot Bearing

1 article

Replacing the Pilot Bearing

1 article

Replacing the Boot

1 article

Installing the sealing ring for the CV joint housing on the wheel spindle

1 article

Finishing

1 article

Seal, Drive Shaft, Replacing

1 article

Install the drive shaft in the transmission

1 article

Install the right drive shaft in the transmission

1 article

Splines, Greasing

1 article

Solenoid Control System, Replacing (For AW55-50 And AW50AWD 2001-)

1 article

Replacing and checking solenoids

1 article

Removing the Control System Cover

1 article

Checking the Resistance Of SLT, SLS And SLU

1 article

Replacing solenoids S1-S5

1 article

Installing the control system

1 article

Solenoid Control System, Replacing (For AW50AWD 2003-)

1 article

Check the resistance in S1-S5

1 article

Removing the control system

1 article

Replacing sealing rings

1 article

Checking the gear selector slider

1 article

Removing cover control system

1 article

Solenoid Control System, Replacing

1 article

Solenoids, Control System, Replacing (For AW50-42 1999)

1 article

Install the lifting beam and lifting hook

1 article

Raise the car

1 article

Sealing the cover

1 article

Install the control system cover

1 article

Reinstall the sub-frame

1 article

Install the steering gear/sub-frame components

1 article

Install the collision protection system over the steering gear (right-hand drive cars)

1 article

Install the heated oxygen sensor (HO2S) bracket

1 article

Install the drive shaft screw

1 article

Install the splashguard under the engine

1 article

General

1 article

Removing the backrest (40%)

1 article

Removing the backrest (60%)

1 article