Removal & Installation
A/C amplifier is located behind center of instrument panel. see scheme 2 Service information is not available from manufacturer.
Body Electronic Control Unit (ECU) is located at driver's side of instrument panel on the fuse/relay box and contains an 18-pin and 20-pin electrical connector. see scheme 3 Service information is not available from manufacturer.
Combination meter is located at center of instrument panel. see scheme 2 Apply tape to end of screwdriver. Using screwdriver, pry at clip areas and remove cluster finish panel. (Scheme 17) Remove screws and disconnect electrical connectors at combination meter. Remove combination meter. To install, reverse removal procedure.
Scheme 17
Driver's door Electronic Control Unit (ECU) is located on driver's door and is incorporated into the power window switch assembly. see scheme 2 Remove screw from end of panel for driver's door ECU. (Scheme 18) Apply tape to end of screwdriver. Using screwdriver, pry upward at each clip on end of panel. (Scheme 18) Disconnect necessary electrical connector and remove driver's door ECU. To install, reverse removal procedure.
Scheme 18
Engine Control Module (ECM) is located behind glove box. see scheme 2 Remove necessary components to access ECM. Remove ECM. To install, reverse removal procedure.
Gateway Electronic Control Unit (ECU) is located behind center of instrument panel and contains a Gray 14-pin electrical connector. see scheme 2 Service information is not available from manufacturer.
Multi-display is located at center of instrument panel. see scheme 2 Service information is not available from manufacturer.