SERVICE OPERATION
- By identifying the vehicle problems thoroughly before service operation, diagnostics work will be performed effectively.
- Before removing parts, confirm the installation condition or the damage of the parts.
- To reinstall parts properly, leave a note of the condition before work as necessary.
- For a part which needs positioning, take appropriate action such as putting alignment marks.
- For a removed part, clean it as necessary and check for damage and defect before installation.
OTHER ADJUSTMENT OPERATIONS BEFORE DELIVERING THE VEHICLE TO CUSTOMER
Due to service and parts replacement convenience, perform the following operations before delivering the vehicle to the customer.
| No. | Item | Check operation | Adjustment operation | Additional adjustment operations when replacing parts |
|---|---|---|---|---|
| 1 | Positions of devices Steering Room mirror Door mirror Seat Air conditioner vent grille | Is the device set to the same position when the vehicle was received from the customer? | Adjust the device to the similar position when the vehicle was received from the customer. | When removing/installing each device Meter, instrument panel, steering column, etc. Room mirror, roof trim, sunroof assembly, etc. Door mirror, door panel, etc. Seat, floor carpet, parking brake lever, etc. Vent grille, instrument panel, console box, etc. |
| 2 | Positions of switches SI-Drive Wiper, light (AUTO or OFF) Headlight beam leveler Illumination control Room light Seat heater, etc. | Is the switch set to the same position when the vehicle was received from the customer? | Set the switch to the same position when the vehicle was received from the customer. | When removing/installing each switch |
| 3 | Position of antenna | Is the antenna set to the same position when the vehicle was received from the customer? | Adjust the position of antenna. | When removing/installing the antenna and washing the vehicle |
IDENTIFICATION NUMBER AND LABEL LOCATIONS
The V.I.N. (Vehicle Identification Numbers) is used to classify the vehicle.
Scheme 1
Scheme 2
Scheme 3
Scheme 4
Scheme 5
Scheme 6
Scheme 7
Scheme 8
Scheme 9
- Positioning of the plate label for identification
- MVSS/CMVSS label
- Model number label
- Engine
- Automatic transmission CVT TR690 TR580
- Manual transmission
- Rear differential T-type VA1-type
GENERAL DESCRIPTION
The purposes of the pre-delivery inspection (PDI) are as follows.
- Remove the additional parts used for ensuring the vehicle quality during transportation and restore the vehicle to its normal condition.
- Check the vehicle before delivery is in normal condition.
- Check the vehicle or parts for any damage occurred during transportation or storage.
- Check the vehicle after repair is in normal condition.
- Make sure to provide a complete vehicle to customer.
For above reasons, all SOAs (dealerships) must carry out the PDIs before delivery of vehicle.
Be sure to perform periodic maintenance in order to maintain vehicle performance and find problems before they occur.