Home ReviewsRefund
Home/Subaru/Forester/Subaru Forester SH рестайлинг (2010-2013)/Repair manual/Communication Devices/Lan Communication System - Lan (Diagnostics): Wiring
Contents Section: Communication Devices All sections

Lan Communication System - Lan (Diagnostics): Wiring Subaru Forester SH рестайлинг

Communication Devices 2 illustrations ~134 words

WIRING DIAGRAM

< Ref. to CAN Communication System in the SYSTEM WIRING DIAGRAMS article. >

Scheme 22

Scheme 22: OPERATION
Scheme 22: OPERATION

Scheme 23

Scheme 23
Scheme 23
  1. Prepare the Subaru Select Monitor kit. < Ref. to «PREPARATION TOOL»(ref-465425-S22451905202012042000000) , General Description. >
  2. Prepare PC with Subaru Select Monitor installed.
  3. Connect the USB cable to SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor). NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
  4. Connect the diagnosis cable to SDI.
  5. Connect SDI to data link connector located lower portion of the instrument panel (on the driver's side).
  6. Start the PC.
  7. Turn the ignition switch to ON and run the "PC application for Subaru Select Monitor".

More articles — Lan Communication System - Lan (Diagnostics)