OPERATION
When malfunction of airbag system occurs, the DTC stored in airbag control module will be read out.
- On the «Main Menu», select {Each System Check}.
- On the «System Selection Menu», select {Airbag System}.
- After {Airbag System} is displayed, select [OK].
- Select the {Diagnostic Code(s) Display} in "Air-bag System".
- Record the DTC displayed.
Note. For details concerning the operation procedure, refer to the PC application help for Subaru Select Monitor. For details concerning DTCs, refer to "List of Diagnostic Trouble Code (DTC)". Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . If "No diagnostic Code Present" is displayed, the combination meter fault or the open circuit of harness is possible. For the diagnostic procedure, refer to Refer to AIRBAG WARNING LIGHT FAILURE . When the airbag warning light is OFF and "No diagnostic Code Present" is displayed on Subaru Select Monitor, the airbag system is operating properly.
Clear the DTC stored in the airbag control module after repairing the airbag system. (After the breakdown is recovered, the breakdown code for completed recoveries are read out when the next breakdown occurs if the memory clear work is not performed).
- On the «Main Menu», select {Each System Check}.
- On the «System Selection Menu», select {Airbag System}.
- Select the {Clear Memory} in «Airbag System».
- When the "Clear Memory?" is shown on the screen, select the [OK].
- When "Done" is displayed, end the Subaru Select Monitor.
- When "Done" and "Turn OFF the ignition switch" are shown on the display screen, turn the ignition switch to OFF.
Note. For details concerning the operation procedure, refer to the PC application help for Subaru Select Monitor. After the memory is cleared, initial diagnosis of the electronic throttle control is performed. Therefore, start the engine 10 seconds or more after have turning the ignition switch to ON.
Check the operating condition of each sensor in the event of malfunction in the seat belt buckle switch, or when the seat belt buckle switch has been replaced.
- On the «Main Menu», select {Each System Check}.
- On the «System Selection Menu», select {Airbag System}.
- Select the {Status Data} in «Airbag System».
The following table is for support data.
| Item | Display |
|---|
| Seat position sensor LH | (2) |
| Seat position sensor RH | (2) |
| Seat belt buckle switch LH | (6) |
| Seat belt buckle switch RH | Belted (3) /Unbelted (4) /Other (5) /lnitial Setting (1) /- (6) |
| Passenger's airbag control status | ON (7) /OFF (8) /lnitial Setting (1) |
| *1: The seat position is forward. *2: The seat position is rearward. *3: Displayed when data other than before and behind the seat, such as the breakdown etc, is input. (1) Displayed when it is initial. (2) Seat position sensor not supported (3) Seat belt fastened (4) Seat belt not fastened (5) Displayed when data other than belt fastened or not fastened, such as breakdowns is input. (6) Seat belt buckle switch not supported (7) Passenger's airbag operating state (8) Passenger's airbag non-operating state |
| (1) | Displayed when it is initial. |
| (2) | Seat position sensor not supported |
| (4) | Seat belt not fastened |
| (5) | Displayed when data other than belt fastened or not fastened, such as breakdowns is input. |
| (6) | Seat belt buckle switch not supported |
| (7) | Passenger's airbag operating state |
| (8) | Passenger's airbag non-operating state |
SUPPORT DATA REFERENCE CHART
Note. For details concerning the operation procedure, refer to the PC application help for Subaru Select Monitor.
