OPERATION OF SELECT LEVER
Check there is no noise, dragging or contact pattern in each select lever range.
| WARNING | Stop the engine while checking operation of the select lever. |
Scheme 405
OPERATION
Refer to "Subaru Select Monitor" for information about how to clear a DTC.
CLEAR MEMORY MODE OPERATION, SUBARU SELECT MONITOR. >
When any on-board diagnostics item is malfunctioning, AT OIL TEMP warning light blinks from the time malfunction is detected after starting the engine until ignition switch is turned to OFF. The malfunctioning part or unit can be determined by a DTC during the on-board diagnostics operation. Problems which occurred previously can also be identified through the memory function. If the AT OIL TEMP warning light does not show a problem (although a problem is occurring), the problem can be determined by checking the performance characteristics of each sensor using Subaru Select Monitor. Indicator light signal patterns are as shown in the figure.
