Home ReviewsRefund
Home/Saturn/Aura/Saturn Aura I (2006-2010)/Repair manual/Communication Devices/Data Communication System: Removal & Installation
Contents Wiring diagrams Section: Communication Devices All sections

Data Communication System: Removal & Installation Saturn Aura I

Communication Devices ~148 words

Removal Procedure

  1. Disconnect the negative battery cable. Refer to «Battery Negative Cable Disconnection and Connection (LAT)»(ref-301498-S16025379472008101700000) or «Battery Negative Cable Disconnection and Connection (LZ4/LY7)»(ref-301498-S23733685642008101700000) .
  2. Remove the right console trim panel. Refer to «Front Floor Console Side Trim Panel Replacement - Right Side»(ref-301482-S37378571642008101700000) .
  3. Remove the body control module (BCM) screws.
  4. Remove the BCM wire harness connectors.
  5. Remove the BCM.

Installation Procedure

  1. Install the BCM.
  2. Install the BCM wire harness connectors.
  3. Install the BCM screws. Tighten: Tighten the screws to 2.5 N.m (22 lb in).
  4. Install the right console trim panel. Refer to «Front Floor Console Side Trim Panel Replacement - Right Side»(ref-301482-S37378571642008101700000) .
  5. Connect the negative battery cable. Refer to «Battery Negative Cable Disconnection and Connection (LAT)»(ref-301498-S16025379472008101700000) or «Battery Negative Cable Disconnection and Connection (LZ4/LY7)»(ref-301498-S23733685642008101700000) .
  6. For a new or remanufactured BCM, setup the BCM. Refer to «Control Module References»(ref-301518-S12838675482008101700000) .

More articles — Data Communication System