Home ReviewsRefund
Home/Saab/9-3/Saab 9-3 II (2002-2008)/Repair manual/Glass, Windows and Mirrors/Programming for garage with fixed code
Contents Wiring diagrams Section: Glass, Windows and Mirrors All sections

Programming for garage with fixed code Saab 9-3 II

Glass, Windows and Mirrors 3 illustrations ~199 words

Programming for garage with fixed code

The garage opener can record and store the frequencies of three different remote controls.

The battery in the remote control should be fairly new for programming to work well.

Scheme 261

Scheme 261: Programming for garage with fixed code
Scheme 261: Programming for garage with fixed code
  1. Turn the ignition ON.
  2. Hold the garage door remote control 3-7 cm below the rearview mirror. Sit where you can see the LED during programming.
  3. Press the remote control button and the desired button on the rear view mirror at the same time.
  4. The LED will now start to flash, slowly at first and then rapidly. The rapidly flashing LED indicates that programming is complete and that you can release the buttons.

Scheme 262

Scheme 262: Reprogramming a button
Scheme 262: Reprogramming a button

Scheme 263

Scheme 263
Scheme 263
  1. Turn the ignition ON.
  2. Press and hold the desired button on the rearview mirror for the entire programming procedure.
  3. The LED will start to flash slowly after 20 seconds.
  4. Hold the garage door remote control 3-7 cm from the rearview mirror and press the button on the remote control.
  5. Reprogramming is complete when the LED starts to flash rapidly. The previous frequency is now erased and replaced by the new one. Reprogramming one button does not affect the other buttons.