Assembly work
1. Insert coolant pipe with new O-ring in ATF cooler and screw in fastening screw.
| Location | Explanation | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Fastening screw | Fastening screws between coolant pipes and ATF cooler | Tightening torque | 17 ftlb. |
2. Insert coolant pipe with new O-ring in ATF cooler and screw in fastening screw.
| Location | Explanation | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Fastening screw | Fastening screws between coolant pipes and ATF cooler | Tightening torque | 17 ftlb. |
3. Install engine mount for exhaust system and tighten fastening screws between transmission and engine mount for exhaust system.
| Location | Explanation | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Exhaust system holder | Fastening screws between transmission housing holder | Tightening torque | 33.3 ftlb. |
4. Remove hose clamp 3094 from coolant pipes (flow and return sides).
5. Screw in retaining screw between the transmission and the coolant pipe.
| Location | Explanation | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Retaining screw | Retaining screws between coolant pipe and transmission | Tightening torque | 17 ftlb. |
6. Connect the plug connection for the multi-function switch.
Scheme 74
7. Plug in transmission socket plug and turn clockwise up to the stop.
8. Engage selector cable in support bracket and push onto ball journals.
9. Fit drive shafts on the transmission side. For this purpose, tighten six hexagon socket screws between the drive shaft and the transmission flange, respectively. Counter on the brake disc or activate the parking brake to avoid simultaneous turning.
| Location | Explanation | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Drive shafts | Fastening screws between drive shaft and transmission flange | Tightening torque | 60 ftlb. |
10. Install cross member.
| Location | Explanation | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Cross member | Fastening screws between cross member and body | Tightening torque | 48 ftlb. |
11. Screw in fastening screws between anti-roll bar and rear axle carrier side member.
| Location | Explanation | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Anti-roll bar | Fastening screws between anti-roll bar and rear axle carrier side member | Tightening torque | 17 ftlb. |
12. Screw vent line onto the engine transport eyebolt.
| Location | Explanation | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Line holder | Fastening screws between line holder and engine transport eyebolt | Tightening torque | 7.4 ftlb. |
13. Push vacuum pipe onto switch-over valve.