Contents Wiring diagrams Section: Body All sections

Interchangeability: body Peugeot 607 I

Body ~343 words

Check the condition of the ball stop: apply the following method

NoteOnly restyled 607 bodies will be delivered by the Spare Parts Division

Parts required

Pre-charge pump support (part number 7119.FK)

Pre-charge pump support (rear - part number 7129.82)

Boot lock striker closing panel (part number 8654.25)

Navigation assistance ECU support (part number 6560.JY)

Body blanks

  • Battery cable drip moulding (part number 5615.A7)
  • Battery cable fixing clip (part number 5615.A7)
  • Blanks (6) (diameter 14 mm - part number 6462.72) (2 X)
  • Plug 35 X 40 (part number 7518.58)
  • Grommet (battery cables - part number 5556.VL)
  • Mounting plate (grommet - part number 5556.VL)

Modification of the structure due to the new location of the battery

(C) structure modifications on vehicle body zone

Front wing inner panel

MIG plug weld: pre-charge pump support (1) (5 points: as (A))

MIG plug weld: pre-charge pump support (2) (rear - 4 points: as (B))

Boot lock striker closing panel

Position: boot lock striker closing panel (3)

Left rear floor extension

Previous assembly

New assembly

Rear floor extension (previous harness routing: 607)

Mark then drill 1 32 mm diameter hole(s) (at C)

Mark then drill 1 6,0 mm diameter hole(s) (at D)

Sill front closing panel

Previous assembly

New assembly

(4) battery cable drip moulding

(5) battery cable fixing clip

Close the opening: sill front closing panel

Rear left wing inner panel (rear structure)

Previous assembly

New assembly

(6) blanks (diameter 14 mm)

(8) grommet (battery cables)

(9) mounting plate (grommet)

Close the openings: rear left wing inner panel (rear structure)

Passenger compartment side rear section

(6) blanks (diameter 14 mm)

Close the opening

Rear left wing inner panel (front structure)

Previous assembly

New assembly

(7) plug 35 X 40

Close the opening: rear left wing inner panel (front structure)

Bulkhead

Cable passage: accelerator

Drill a 18 mm diameter hole (at (E))

Inner sill

Previous assembly

New assembly

Drill 2 holes to a diameter 9,0 mm (at (F))

Position: 2 rivet nuts M6 X 100 (at (F))

Navigation assistance ECU support

Position: navigation assistance ECU support (10)