Alternator, Disassemble
| .D. ICON01.tif | 0,75 | 0,75 | tiff;; Remove, Disconnect |
Alternator - see corresponding operation.
| .D. ICON03.tif | 0,75 | 0,75 | tiff;; Disassemble |
|---|---|---|---|
| Cable from terminal ‘B’- rubber cap and nut; clip. | |||
| .D. ICON03.tif | 0,75 | 0,75 | tiff;; Disassemble |
Insulating sleeve from terminal ‘B’.
Through bolts - mark position of front and rear housings relative to stator.
Front housing with armature from stator and rear housing - use screwdriver to carefully separate.
| Nuts that secure stator to rear housing | |||
|---|---|---|---|
| .P. T3504.tif | 9 | 7,5 | tiff;; |
| .D. ICON03.tif | 0,75 | 0,75 | tiff;; Disassemble |
| Stator with diode plate and brush holder from rear housing - use screwdriver to carefully lever out. | |||
| .P. C7211.tif | 9 | 7,5 | tiff;; |
| .D. ICON03.tif | 0,75 | 0,75 | tiff;; Disassemble |
Pulley nut and washer from armature - use soft-jawed vice.
| Pulley, front housing and fan from armature. | |||
|---|---|---|---|
| .P. T3502.tif | 9 | 7,5 | tiff;; |
| .D. ICON03.tif | 0,75 | 0,75 | tiff;; Disassemble |
Bearing from armature - use puller (see illustration).
Bearing reainer from front housing - screws.
| Bearing from front housing - press out manually or drive out with suitable drift. | |||
|---|---|---|---|
| .P. T3510.tif | 9 | 7,5 | tiff;; |
| .D. ICON03.tif | 0,75 | 0,75 | tiff;; Disassemble |
Stator leads from diode plate - unsolder connections (arrowed).
| .D. ICON11.tif | 0,75 | 0,75 | tiff;; Important! |
|---|---|---|---|
| Hold wire to diode with long-nose pliers to prevent overheating of diode. | |||
| .P. C7215.tif | 9 | 7,5 | tiff;; |
| .D. ICON03.tif | 0,75 | 0,75 | tiff;; Disassemble |
| Brush holder from diode plate - insulating sleeve and bolt (A), and unsolder connection (arrowed). | |||
| .P. C7216.tif | 9 | 7,5 | tiff;; |
| .D. ICON03.tif | 0,75 | 0,75 | tiff;; Disassemble |
| Regulator from brush holder - unsolder connections. | |||
| .P. U2532.tif | 9 | 7,5 | tiff;; |