Checking Program - Cruise Control Monterey
Test Instructions
· Be sure that during measurements all other current consumers are switched off (including the interior lights).
· Take measurements between the terminals stated in the checking program with the relevant adapter cables from the Electronic Kit I KM - 609.
· When connecting the adapter cables do not use force.
· When checking, the specified sequence of test steps must be followed exactly.
· If at any step the desired nominal value is not reached for a test step, the fault must be eliminated before the next test step is undertaken.
· When using the multimeter, note that the correct range specified in the test steps must always be set before connection of the measuring leads.
· The nominal values given in the checking program are only valid if the multimeter MKM - 587 - A is used.
· If in the checking program all nominal values are attained and the cruise control system is not functioning as described in the function check (chapter 4.1) the control unit K14 must be replaced.
· During checks, there may be deviations in the lead colours in individual cases.
It is recommended that, for vehicles other than MY'94, the circuit diagrams for the relevant Model Year in the Technical Information Bulletins (TI) are to be used.