Immobiliser System Modification F7: PROGRAMMING
PROGRAM TP-KEY
| Conditions for Checking | Nominal Value |
Affected terminals: -
Possible trouble codes: -
Note:
Using this TECH 1 function, the transponder keys can be programmed consecutively and individually into the immobiliser control unit. For this, the immobiliser control unit reads out the key's transponder code and stores it.
Important:
If a transponder key is lost, in the interests of safety the transponder codes in all other remaining transponder keys must be deleted in the immobiliser control unit and reprogrammed together with the new transponder key (delete transponder keys, see section 3.1.5.2).
Press key F7 in the system main menu, select the desired test using the arrow keys and confirm with YES. Follow the instructions in the TECH 1 display.
Ignition OFF
Insert the first transponder key to be programmed in the ignition lock
Ignition ON
Ignition OFF
If the display on the right appears after programming, the transponder key has been successfully programmed. Proceed with the programming of the next transponder key.
| TRANSPONDER KEY |
PROGRAMMING
COMPLETED!
| If the display on the right appears, the immobiliser control unit has to be programmed (security code, engine type, mechanical key number, vehicle identification number), before programming of the transponder keys can proceed. | PROGRAM IMMO. |
BEFORE NEXT
KEY PROGRAMMING!
| If the display on the right appears, the transponder key has already been programmed. If it is to be reprogrammed, the old transponder code must first be deleted (see section 3.1.5.2) | TRANSPONDER KEY |
ALREADY
| PROGRAMMED! |