Home ReviewsRefund
Home/Opel/Antara/Opel Antara I (2007-2011)/Repair manual/Electronic Module/X-Body Control Module (BCM) Replace (Captiva)
Contents Wiring diagrams Section: Electronic Module All sections

X-Body Control Module (BCM) Replace (Captiva) Opel Antara I

Electronic Module 6 illustrations ~123 words

X-Body Control Module (BCM) Replace (Captiva)

Remove

  1. Disconnect the negative battery cable.

2. Remove the instrument cluster. Refer to Instrument Cluster Replace (Captiva) .

3. You can see the X-BCM through the bracket hole and put your hands into the hole along the arrow.

  1. Unlock both sides of X-BCM and remove two nuts through the hole.

5. Pull out the bracket through the hole.

  1. Disconnect the electrical connector.
  2. Pull out the X-BCM through the hole.

Important: Perform the SPO reprogramming when X-BCM module replaced.

Install

  1. Connect the electrical connector.

2. Install the X-BCM and bracket with the nuts into the hole.

  1. Install the instrument cluster. Refer to Instrument Cluster Replace (Captiva) .
  2. Connect the negative battery cable.

More articles — Electrical Equipment and Instruments