Body Control Module (BCM) Replace (Antara) Opel Antara I



Body Control Module (BCM) Replace (Antara)

Remove

1. Disconnect the negative battery cable.
2. Remove the audio and the aircon switch.
3. Remove the shift control lever assembly or housing. For Automatic Transmission refer to Shift Control Lever Assembly Replace . For Manual Transmission refer to Shift Control Lever Housing Replace .
4. Disconnect the electrical connectors.
5. Remove the body control module (BCM).

Install

1. Install the body control module (BCM).
2. Connect the electrical connectors.
3. Remove the shift control lever assembly or housing. For Automatic Transmission refer to Shift Control Lever Assembly Replace . For Manual Transmission refer to Shift Control Lever Housing Replace .
4. Install the audio and the aircon switch.
5. Connect the negative battery cable.

The procedures below are designed to program the BCM correctly during BCM related service. Before you start, read these procedures carefully and completely.

Note: The vehicle will not start and many other functions may not operate properly if a replacement BCM is not properly set up. The following procedures must be followed:

1. Programming the BCM
2. Learning the restraints ID

Programming the BCM

From the Main Menu, select Service Programming System, then follow the instructions on the screen.

Learning the Restraints ID

Navigate on the scantool to Body > Body Control Module > Programming > SDM ID, then follow the instructions on the screen.