SPECIFICATIONS
| Application | Specification |
|---|
| Compressor Type | Sanden Scroll |
| Compressor Belt Tension | (1) |
| System Oil Capacity (2) |
| With Rear A/C | 8.5 ozs. |
| Without Rear A/C | 7.4 ozs. |
| Refrigerant (R-134a) Capacity |
| With Rear A/C | 48 ozs. |
| Without Rear A/C | 29 ozs. |
| System Operating Pressures (3) |
| High Side |
| With Rear A/C | 161-213 psi (11.3-15.0 kg/cm 2 ) |
| Without Rear A/C | 160-200 psi (11.2-14.1 kg/cm 2 ) |
| Low Side |
| With Rear A/C | 43-57 psi (3.0-4.0 kg/cm 2 ) |
| Without Rear A/C | 31-44 psi (2.2-3.1 kg/cm 2 ) |
| (1) Tighten serpentine belt until indicator mark on movable portion of belt tensioner is within limits of slotted area on stationary portion of belt tensioner. (2) Use PAG oil. (3) Specification is with ambient temperature at 76-85°F (24-29°C), relative humidity at 35-50 percent. |
| (1) | Tighten serpentine belt until indicator mark on movable portion of belt tensioner is within limits of slotted area on stationary portion of belt tensioner. |
| (3) | Specification is with ambient temperature at 76-85°F (24-29°C), relative humidity at 35-50 percent. |
Fastener Tightening Specifications
| Application | Specification |
|---|
| Metric | English |
| Actuator Retaining Screw, ALL | 1.9 N.m | 17 lb in |
| Blower Motor Control Processor Mounting Screw | 1.9 N.m | 17 lb in |
| Blower Motor Resistor Mounting Screw | 1.9 N.m | 17 lb in |
| HVAC Control Module Screw | 1.9 N.m | 17 lb in |
Fastener Tightening Specifications
