Home ReviewsRefund
Home/Nissan/Sentra/Nissan Sentra B16 рестайлинг (2009-2012)/Repair manual/Procedures/Maintenance: Removal & Installation
Contents Section: Procedures All sections

Maintenance: Removal & Installation Nissan Sentra B16 рестайлинг

Procedures ~344 words

INSTALLATION

Installation is in the reverse order of removal.

  1. Install rocker cover gasket to rocker cover.
  2. Install rocker cover. Tighten bolts in two steps separately in numerical order as shown in illustration. 1st step : 1.96 N.m (0.20 kg-m, 17 in-lb) 2nd step : 8.33 N.m (0.85 kg-m, 73 in-lb) <= Engine front CAUTION: Check if rocker cover gasket is not dropped from the installation groove of rocker cover.
  3. Install spark plug using suitable tool. Application Except for California For California Make : NGK : Denso Part number : PLZKAR6A-11 : FXE20HR-11 Gap (nominal) : 1.1 mm (0.043 in) : 1.1 mm (0.043 in) CAUTION: Never drop or shock it.
  4. Install ignition coil. CAUTION: Handle it carefully and avoid impacts. Never disassemble.
  5. Install intake manifold. Refer to «INTAKE MANIFOLD»(ref-367306-S34771371052010072700000) .

REMOVAL

  1. Disconnect the mass air flow sensor electrical connector.
  2. Disconnect the tube clamp at the electric throttle control actuator and the fresh air intake tube.
  3. Remove air cleaner to electric throttle control actuator tube, air cleaner case, with mass air flow sensor attached. Add marks as necessary for easier installation.
  4. Remove mass air flow sensor from air cleaner case, as necessary. CAUTION: Handle the mass air flow sensor with care: Do not shock it. Do not disassemble it. Do not touch the internal sensor.
  5. Remove ECM bracket and CVT controller, as necessary.
  6. Remove the resonator in the fender, as necessary.

Installation is in the reverse order of removal.

  1. Align marks.
  2. Attach each joint securely.
  3. Screw clamps firmly.
  1. Remove foreign materials adhering to the oil filter installation surface.
  2. Apply new engine oil to the oil seal contact surface of the new oil filter.
  3. Screw the new oil filter manually until it touches the installation surface, then tighten it by 2/3 turn. Or tighten to specification. Oil filter : 17.7 N.m (1.8 kg-m, 13 ft-lb)
  4. Refill engine with new oil. Refer to " «CHANGING ENGINE OIL»(ref-367326-S12680536362010072700000) ".
  5. Install splash shield RH. Refer to " «REMOVAL AND INSTALLATION»(ref-367309-S17675621432010072700000) ".

Installation is in the reverse order of removal.

Spark Plug Types

MakeNGK
Part numberDILKAR6A-11
Gap (nominal)1.1 mm (0.043 in)

SPARK PLUG SPECIFICATIONS

More articles — Maintenance