ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
| CAUTION | To adjust neutral position of steering angle sensor, make sure to use CONSULT. (Adjustment cannot be done without CONSULT). |
- ALIGN THE VEHICLE STATUS Stop vehicle with front wheels in straight-ahead position. : GO TO 2
- PERFORM THE NEUTRAL POSITION ADJUSTMENT FOR THE STEERING ANGLE SENSOR On the CONSULT screen, touch "WORK SUPPORT" and "ST ANG SEN ADJUSTMENT" in order. Touch "START". CAUTION: Do not touch steering wheel while adjusting steering angle sensor. After approximately 10 seconds, touch "END". NOTE: After approximately 60 seconds, it ends automatically. Turn ignition switch OFF, then turn it ON again. CAUTION: Be sure to perform above operation. : GO TO 3
- CHECK DATA MONITOR Run vehicle with front wheels in straight-ahead position, then stop. Select "DATA MONITOR". Then make sure "STR ANGLE SIG" is within 0±2.5°. Is the steering angle within the specified range? YES: GO TO 4 NO: Perform the neutral position adjustment for the steering angle sensor again, GO TO 1
- ERASE THE SELF-DIAGNOSIS MEMORY Erase the self-diagnosis memory of the ABS actuator and electric unit (control unit) and ECM. ABS actuator and electric unit (control unit): Refer to " «CONSULT FUNCTION (ABS)»(ref-675599-S00147093492014120500000) ". ECM: Refer to " «CONSULT FUNCTION»(ref-675578-S05166819052014120500000) ". Are the memories erased? YES: Inspection End NO: Check the items indicated by the self-diagnosis.
