Home ReviewsRefund
Home/Nissan/Juke/Nissan Juke I (2010-2014)/Repair manual/Engine Control Systems/Drive Mode System (Integrated Control System): Diagnosis
Contents Wiring diagrams Section: Engine Control Systems All sections

Drive Mode System (Integrated Control System): Diagnosis Nissan Juke I

Engine Control Systems ~182 words

DETAILS OF TROUBLE DIAGNOSIS FLOWCHART

  1. OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurs. GO TO 2.
  2. CHECK SYMPTOM Check the symptom based on the information obtained from the customer. Check if any other malfunctions are present. GO TO 3.
  3. CONSULT SELF-DIAGNOSIS Perform "MULTI DISPLAY" "self diagnosis" by connecting CONSULT. When DTC is detected, follow the instructions below: Record DTC and Freeze Frame Data. NOTE: If "CAN COM CIRC [U1000]" is displayed, start the diagnosis from the CAN communication system. Refer to " «DIAGNOSIS PROCEDURE»(ref-516457-S37357724952012120600000) ". Is any DTC No. displayed? YES: GO TO 4. NO: GO TO 5 .
  4. DTC/SYSTEM DIAGNOSIS Perform a DTC/system diagnosis and repair or replace any malfunctioning part. GO TO 6 .
  5. PERFORM DIAGNOSIS BY SYMPTOM Perform a diagnosis by symptom and repair or replace any malfunctioning part. GO TO 6.
  6. FINAL CHECK Check that the multi display unit functions normally. Does it operate normally? YES: End of trouble diagnosis NO: GO TO 2 .

More articles — Drive Mode System (Integrated Control System)