Home ReviewsRefund
Home/Nissan/Juke/Nissan Juke I (2010-2014)/Repair manual/Engine Control Systems/Accelerator Control System: Removal & Installation
Contents Wiring diagrams Section: Engine Control Systems All sections

Accelerator Control System: Removal & Installation Nissan Juke I

Engine Control Systems

REMOVAL

  1. Remove instrument panel lower cover driver side.
  2. Disconnect accelerator pedal position sensor harness connector.
  3. Loosen mounting bolts, and remove accelerator pedal assembly.
CAUTIONNever disassemble accelerator pedal assembly. Never remove accelerator pedal position sensor from accelerator pedal assembly. Avoid impact from dropping etc. during handling. Be careful to keep accelerator pedal assembly away from water.

INSTALLATION

Note the following, and install in the reverse order of removal.

  1. Insert the locating pin while inserting the locating hook in to the break pedal bracket. Tighten mounting bolts to accelerator pedal assembly.
CAUTIONNever squeeze the locating hook into the break pedal bracket when inserting the locating pin into the hole on the brake pedal bracket side.

More articles — Accelerator Control System