Precautions for Harness Repair
- Solder the repaired area and wrap tape around the soldered area. NOTE: A fray of twisted lines must be within 110 mm (4.33 in).
- Bypass connection is never allowed at the repaired area. NOTE: Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.
- Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.
Scheme 20
Scheme 20: Interview Sheet
Scheme 21
Scheme 21: Diagnosis Sheet (CAN Type 1)
Scheme 22
Scheme 22: Diagnosis Sheet (CAN Type 2)
Scheme 23
Scheme 23: Diagnosis Sheet (CAN Type 3)
Scheme 24
Scheme 24: Diagnosis Sheet (CAN Type 4)
Scheme 25
Scheme 25: Diagnosis Sheet (CAN Type 5)
Scheme 26
Scheme 26: Diagnosis Sheet (CAN Type 6)
