Home ReviewsRefund
Home/Mitsubishi/Lancer/Mitsubishi Lancer X рестайлинг (2011-2015)/Repair manual/Anti-Lock/traction Control/DTC C2003: Control Parameter Not Implement
Contents Section: Anti-Lock/traction Control All sections

DTC C2003: Control Parameter Not Implement Mitsubishi Lancer X рестайлинг

Anti-Lock/traction Control
CAUTIONIf there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to CAN BUS LINE DIAGNOSTIC FLOW ). If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines. If DTC C2003 is set in ASC-ECU, always diagnose the CAN bus line. If there is any fault in the CAN bus lines, an incorrect DTC may be set. In this case, the set DTC is not highly reliable. Before replacing the ECU, ensure that the communication circuit is normal. When DTC C2003 is set in ASC-ECU, the DTC may also be set in ETACS-ECU. When the DTC is set in ETACS-ECU, carry out the diagnosis of the DTC for ETACS-ECU first. When the hydraulic unit (integrated with ASC-ECU) is replaced, always carry out the calibration of the steering wheel sensor, the G and yaw rate sensor and brake fluid pressure sensor (Refer to G AND YAW RATE SENSOR CALIBRATION , STEERING WHEEL SENSOR CALIBRATION and BRAKE FLUID PRESSURE SENSOR CALIBRATION ).

More articles — Active Stability Control System (Asc) - Lancer