3. AIR CLEANER ELEMENT (REPLACE)
The air cleaner element will become dirty during use, reducing its effectiveness. Replace it with a new one.
REPLACEMENT OF AIR CLEANER ELEMENT
- Unclamp the air cleaner cover.
- Remove the air cleaner element and install a new one.
- When clamping the air cleaner cover in place, be sure that the cover is completed closed.
Scheme 22
6. IGNITION CABLES (REPLACE)
| CAUTION | When disconnecting an ignition cable, be sure to hold the cable boot. If the cable is disconnected by pulling on the cable alone, you might break the cable. |
Scheme 23
The ignition cables should be replaced periodically with new ones. After replacing, make sure that the ignition cables are routed properly and fully seated.
7. TIMING BELT (REPLACE)
Replace the belt with a new one according to the maintenance schedule on (P.00-33) to assure proper engine performance.
For removal and installation procedures, refer to TIMING BELT .
10. ENGINE OIL FILTER (REPLACE)
The quality of replacement filters varies considerably. Only high quality filters should be used to assure most efficient service.
Genuine oil filters require that the filter is capable of withstanding a pressure of 1,765 kPa (256 psi) are high quality filters and are recommended as follows
- Mitsubishi Oil Filter Part Number
- MD136466, MD322508, MD325714, MD332687, MD360935, MD365876 or equivalent
Replace The Side Impact Sensor If It Fails The Visual Check
Refer to SIDE IMPACT SENSOR .