Generators & Regulators - Evolution: Overhaul Mitsubishi Lancer IX

Disassembly Service Points

1. A) Front Bracket Assembly Removal - Insert the blades of screwdrivers between the front bracket assembly and stator core, and pry and separate them with the screwdrivers. (Scheme 28)
2. B) Alternator Pulley Removal - Clamp the rotor in a vise with the pulley facing up to remove the pulley.
3. C) Stator/Regulator Assembly Removal - Unsolder the stator leads from the main diode of the rectifier assembly when the stator is removed. When removing the rectifier assembly from the regulator assembly, undo the soldered points on the rectifier assembly. (Scheme 29)

Scheme 28

Scheme 29

Assembly Service Points

1. A) Regulator Assembly Installation - After installing the regulator assembly, insert a wire through the hold provided on the rear bracket while pressing down on the brush, and secure the brush. (Scheme 30)
2. B) Rotor Assembly Installation - After installing the rotor, remove the wire used to secure the brush.

Scheme 30