Identifying Mark (emblem) - Except Lancer Evolution Mitsubishi Lancer Evolution X

Scheme 18

Scheme 19

Scheme 20

Scheme 21

Scheme 22

Scheme 23

Scheme 24

Scheme 25

1. 2. Rear three-diamond mark
2. 3. MITSUBISHI mark
3. 4. LANCER mark
4. 5. LANCER mark
5. GT mark
6. 7. RALLIART mark
7. 8. RALLIART mark

Scheme 26

Scheme 27

Scheme 28

Scheme 29

Scheme 30

1. 3. Rear three-diamond mark
2. 4. MITSUBISHI mark
3. 5. LANCER mark
4. 6. LANCER mark
5. 7. RALLIART mark

1. Installation position Attach each mark to the position shown in the illustration.
2. Installation procedure Use 3M™ AAD Part number 8906 or equivalent to clean the mark installation surfaces on the body. CAUTION: When attaching the marks, the ambient temperature should be 20 - 38°C (68 - 100°F) and the air should be completely free of dust. If the ambient temperature is lower than 20°C (68°F), the marks and the places on the vehicle body where the marks are to be attached should be heated to 20 - 30°C (68 - 86°F). Peel off the protection sheet on the back of the marks to affix it in position.