Home/Mitsubishi/Lancer Evolution/Mitsubishi Lancer Evolution X (2007-2016)/Repair manual/Door System - Except Lancer Evolution/DIAGNOSTIC TROUBLE CODE CHART

Contents

Section: Door System - Except Lancer Evolution

CENTRAL DOOR LOCKING SYSTEM

POWER WINDOWS

SERVICE SPECIFICATIONS

SEALANT

COMPONENT IDENTIFICATIONS

TROUBLESHOOTING STRATEGY

TROUBLE SYMPTOM CHART

INSPECTION PROCEDURE 1: Central Door Locking System does not work at All

CIRCUIT OPERATION

TROUBLESHOOTING HINTS

DIAGNOSTIC PROCEDURE

INSPECTION PROCEDURE 2: Central Door Locking System does not Operate even when Door Lock Switch of Power Window Main Switch Operated (Door Lock Switch of Front Power Window Sub Swi

TECHNICAL DESCRIPTION (COMMENT)

INSPECTION PROCEDURE 5: Selector "P" Position-linked Door Unlock Function does not Operate Normally. CVT, TC-SST >

OPERATION

INSPECTION PROCEDURE 6: Ignition "LOCK (OFF)" Position-linked Door Unlock Function does not Operate. < M/T, CVT, TC-SST >

DIAGNOSTIC TROUBLE CODE CHART

CODE NO. L0730: P/W (DR) SW pulse 1 disconnection

COMMENTS ON TROUBLE SYMPTOM

PROBABLE CAUSES

CODE NO. L0732: P/W (DR) SW pulse 2 disconnection

CODE NO. L0734: P/W (DR) Above window position

CODE NO. L0736: P/W (DR) Sensor fail (ground)

CODE NO. L0740: P/W (DR) 3 times jam - protection

CODE NO. L0746: P/W (DR) Parameter read fail; CODE NO. L0750: P/W (DR) Position read fail

INSPECTION PROCEDURE 1: Power Windows do not work at All

INSPECTION PROCEDURE 2: Driver's Power Window does not work by means of The Power Window Main Switch

INSPECTION PROCEDURE 3: Relevant Power Window(s) does not work by means of the Front and Rear Passenger's Power Window Sub Switches

INSPECTION PROCEDURE 4: Front and/or Rear Passenger's Power Window(s) do not work by means of the Power Window Main Switch

TROUBLESHOOTING HINT

INSPECTION PROCEDURE 5: The Power Window Timer Function does not work Normally

INTRODUCTION TO GLASS AND DOOR DIAGNOSIS

GLASS AND DOOR DIAGNOSTIC TROUBLESHOOTING STRATEGY

SYMPTOM CHART

DIAGNOSIS

SPECIAL TOOLS

DOOR FIT ADJUSTMENT

DOOR WINDOW GLASS ADJUSTMENT

POWER WINDOW CHECK

GLASS SLIDING MECHANISM CHECK AND ADJUSTMENT

POWER WINDOW TIMER FUNCTION CHECK

LEARNING PROCEDURES OF THE FULLY CLOSED POSITION WHEN THE POWER WINDOW SWITCH IS REMOVED, OR THE POWER WINDOW REGULATOR ASSEMBLY IS REMOVED OR REPLACED

LEARNING PROCEDURES WHEN THE POWER WINDOW SWITCH IS REPLACED WITH A NEW ONE

CENTRAL DOOR LOCKING SYSTEM CHECK

CHECK OF KEY LOCK PREVENTION FUNCTION

SHIFT "P" INTERLINK DOOR UNLOCK FUNCTION CHECK < CVT, TC-SST >

IGNITION "LOCK (OFF)" POSITION-LINKED DOOR UNLOCKING FUNCTION CHECK < M/T, CVT, TC-SST >

CUSTOMIZATION FUNCTION

>> A << STRIKER INSTALLATION

DOOR SWITCH CHECK

POWER WINDOW SWITCH CONTINUITY CHECK

DOOR WINDOW REGULATOR CHECK

REMOVAL AND INSTALLATION

<< A >> DOOR OUTSIDE HANDLE COVER REMOVAL

>> A << DOOR CHECK INSTALLATION

>> B << DOOR INSIDE HANDLE INSTALLATION

>> C << DOOR OUTSIDE HANDLE BASE INSTALLATION

FRONT DOOR LOCK ACTUATOR CHECK

REAR DOOR LOCK ACTUATOR CHECK

CENTRAL DOOR LOCK SWITCH CONTINUITY CHECK

LOCK/UNLOCK SWITCH CHECK < VEHICLE WITH KOS >

<< C >> DOOR OPENING WEATHERSTRIP OUTER REMOVAL

>> A << DOOR OPENING WEATHERSTRIP OUTER INSTALLATION

>> B << WATERPROOF FILM INSTALLATION

>> C << DOOR WINDOW GLASS RUNCHANNEL INSTALLATION

All sections

DIAGNOSTIC TROUBLE CODE CHART Mitsubishi Lancer Evolution X

Door System - Except Lancer Evolution

DIAGNOSTIC TROUBLE CODE CHART

CAUTION

On troubleshooting, if the ignition switch is turned ON while disconnecting connector(s), diagnostic trouble code(s) associated with other system may be set. On completion, check all systems for diagnostic trouble code(s). If diagnostic trouble code(s) are set, erase them all.

Diagnostic trouble code No.	Diagnostic item
L0730	P/W (DR) SW PULSE 1 DISCONNECTION
L0732	P/W (DR) SW PULSE 2 DISCONNECTION
L0734	P/W (DR) ABOVE WINDOW POSITION
L0736	P/W (DR) SENSOR FAIL (GROUND)
L0740	P/W (DR) 3 TIMES JAM - PROTECTION
L0746	P/W (DR) PARAMETER READ FAIL
L0750	P/W (DR) POSITION READ FAIL

DIAGNOSTIC TROUBLE CODE CHART

CAUTION

During diagnosis, a diagnosis code associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, check all systems for diagnosis code(s). If diagnosis code(s) are set, erase them all.

Trouble symptom	Inspection procedure number	Reference
Power windows do not work at all.	1	INSPECTION PROCEDURE 1: POWER WINDOWS DO NOT WORK AT ALL.
Driver's power window does not work by means of the power window main switch.	2	INSPECTION PROCEDURE 2: DRIVER'S POWER WINDOW DOES NOT WORK BY MEANS OF THE POWER WINDOW MAIN SWITCH.
Relevant power window(s) does not work by means of the front and rear passenger's power window sub switches.	3	INSPECTION PROCEDURE 3: RELEVANT POWER WINDOW(S) DOES NOT WORK BY MEANS OF THE FRONT AND REAR PASSENGER'S POWER WINDOW SUB SWITCHES.
Front and/or rear passenger's power window(s) do not work by means of the power window main switch.	4	INSPECTION PROCEDURE 4: FRONT AND/OR REAR PASSENGER'S POWER WINDOW(S) DO NOT WORK BY MEANS OF THE POWER WINDOW MAIN SWITCH.
The power window timer function does not work normally.	5	INSPECTION PROCEDURE 5: THE POWER WINDOW TIMER FUNCTION DOES NOT WORK NORMALLY.
Power window anti-trap function does not work normally. < Driver's side only >	6	INSPECTION PROCEDURE 6: POWER WINDOW ANTI-TRAP FUNCTION DOES NOT WORK NORMALLY. < DRIVER'S SIDE ONLY >
The window glass lowers automatically while it is rising. < Driver's side only >	7	INSPECTION PROCEDURE 7: THE WINDOW GLASS LOWERS AUTOMATICALLY WHILE IT IS RISING < DRIVER'S SIDE ONLY >.

TROUBLE SYMPTOM CHART