Charging System - Generators & Regulators: Removal & Installation Mercury Sable V

REMOVAL AND INSTALLATION

1. Disconnect the battery. For additional information, refer to «BATTERY, MOUNTING AND CABLES»(ref-293478) article.
2. Remove the generator B+ nut and terminal. To install, tighten to 12 Nm (9 lb-ft).
3. Disconnect the generator electrical connector and position the engine wiring harness aside.
4. Position the upper radiator hose aside and remove the upper radiator hose cradle.
5. Remove the 5 pin-type retainers from the wire harness across the top of the radiator and position the harness aside.
6. Rotate the accessory drive belt tensioner and position the accessory drive belt aside.
7. Remove the upper generator nut and stud. To install, tighten the generator stud to 8 Nm (71 lb-in). To install, tighten the generator nut to 47 Nm (35 lb-ft).
8. Loosen the lower generator bolt. To install, tighten to 47 Nm (35 lb-ft).
9. Remove the generator.
10. To install, reverse the removal procedure.