Trouble Code Access
- Use Self-Diagnostic Checker (49 H018 9A1) and System Selector (49 B019 9A0) to retrieve trouble codes. Connect one lead of self-diagnostic checker to ground and the other to system selector. (Схема №1) Connect system selector to data link connector. Connector is located near battery. If system selector is not available, connect a jumper wire between data link connector terminals TEN and GND.
- With ignition on and engine stopped, observe Malfunction Indicator Light (MIL). Note trouble codes. Check TROUBLE CODE IDENTIFICATION chart for possible cause. See CODE CHARTS for test procedures. If light remains on continuously, MIL circuit is grounded or PCME is defective.
Clearing Trouble Codes
Disconnect negative battery cable and depress brake pedal for at least 20 seconds. Reconnect battery cable. Reconnect self-diagnostic checker and system selector. (Схема №1) Turn ignition on, but do not start engine for 6 seconds. Start engine and run at 2000 RPM for 3 minutes. Verify no codes are displayed.