Fill radiator and coolant reservoir. Start engine and allow to idle until cooling fan operates. If temperature increases beyond normal there is excessive air in system. Accelerate engine to 4000 RPM for 1 minute. Repeat several times. Turn on main and rear heaters and verify heat from heater vents. Stop engine and wait until it is cool. Remove filler cap. Verify coolant level is near filler neck. If coolant level is not near filler neck, repeat procedure. Fill coolant reservoir to FULL level.
Contents
Wiring diagrams Section: Mechanical- Removal & Installation
- Removal & Installation: Overview
- Removal & Installation: Diagnosis
- Removal & Installation: Removal & Installation
- Abbreviations
- Accessory Drive Belts
- Adjustments
- Airbag
- Anti-Lock/traction Control
- Application
- Automatic Trans
- Auxiliary Emission Control Systems
- Axle Shafts
- Basic Trouble Shooting
- Brakes
- Cabin Air Filter
- Charging System
- Check Lists
- Computer Relearn
- Cooling Fan
- Cruise Control Systems
- Diagnostic Connector Locations
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- DTC Index
- Electrical
- Electrical Component Locations
- Emission Applications
- Engine
- Engine Performance
- Exterior Lights
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing - All Makes
- Headlights
- Heated Glass/defoggers
- Identification
- Interior/illumination Lights
- Manual & Power Steering
- Manual HVAC System
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Mode 6
- Oem General Information
- Pin Voltage Charts
- Removal & Installation
- Restraints
- Sensor Range Charts
- Specifications
- Starter
- Steering
- Steering Column
- Steering Column Switches
- Sun Roof/t-Top/convertible Top
- Suspension Rear
- Testing & Diagnostics
- Theory & Operation
- Traction Control Disable
- Transmission
- Warning System
- Wheel Alignment
- Windows
- Wiper/washer Systems
- Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.)