Home ReviewsRefund
Home/Mazda/CX-7/Mazda CX-7 I рестайлинг (2009-2012)/Repair manual/Steering Column Switches/Lighting Systems: Overhaul
Contents Section: Steering Column Switches All sections

Lighting Systems: Overhaul Mazda CX-7 I рестайлинг

Steering Column Switches 2 illustrations

COMBINATION SWITCH DISASSEMBLY/ASSEMBLY

WARNINGDo not remove the steering angle sensor as a single unit. Otherwise, the disc inside the steering angle sensor will deform when the steering angle sensor is installed causing the neutral position to deviate, and may prevent the steering system, which uses the steering angle sensor, from functioning normally. If the steering angle sensor is replaced or the sensor is mistakenly removed, replace the combination switch body.

Scheme 33

Scheme 33
Scheme 33
  1. Disassemble in the order indicated in the table.
  2. Assemble in the reverse order of disassembly.

Scheme 34

Scheme 34: LIGHT SWITCH REMOVAL/INSTALLATION
Scheme 34: LIGHT SWITCH REMOVAL/INSTALLATION
  1. Disconnect the negative battery cable.
  2. Remove the column cover. (See «COLUMN COVER REMOVAL/INSTALLATION»(ref-375422-S22241475042010102800000) .)
  3. Disconnect the connector.
  4. Remove the screws.
  5. Remove the light switch.
  6. Install in the reverse order of removal.

More articles — Lighting Systems