To install, reverse removal procedure. Adjust tension of all drive belts. Reconnect fuel pump relay. Restore all fluids to proper level. Reconnect airlfow meter connector. See TORQUE SPECIFICATIONS .
Scheme 1
Scheme 2
- Apply parking brake and block rear wheels. Start engine and disconnect fuel pump relay. (Scheme 2) Allow engine to stall. Turn ignition off. Reconnect fuel pump relay.
- Disconnect negative battery cable. Remove hood. Raise and support front of vehicle. Drain engine oil and coolant. Remove fresh air duct, air cleaner and air intake tube. Disconnect accelerator cable.
- Remove cooling fan and fan shroud. Remove water pump drive belt. Remove spark plug cables and spark plugs. Remove canister and power brake vacuum hoses.
- Remove fuel hoses from pressure regulator, making sure to cover hose fitting with rag to prevent fuel spray. Plug disconnected hoses to prevent fuel leakage.
- Disconnect heater hoses from engine. Disconnect engine wiring harness. Remove engine undercover and radiator hoses. Disconnect automatic transmission cooling lines from radiator (if equipped).
- Remove radiator wiring harness and radiator. Remove alternator and adjusting bracket. Remove A/C compressor and power steering pump and tie aside with hoses still connected.
- Remove exhaust pipe. Remove driveshaft and transmission. Remove engine mount nuts and remove engine. (Scheme 3)
