Connector Disconnection
- Disconnect the negative battery cable before performing any work that requires handling of connectors. (See «BATTERY REMOVAL/INSTALLATION [L3]»(ref-244326-S41790335602006092100000) ).
Brake Lines Disconnection
- If any brake line has been disconnection during the procedures, add brake fluid, bleed the brake, and inspect for leakage after the procedure has been completed. CAUTION: Brake fluid will damage painted surfaces. Be careful not to spill any on painted surfaces. If it is spilled, wipe it off immediately.
EHPAS Related Parts
| WARNING | If the configuration procedure is not completed, the EHPAS will not operate properly and It might cause an unexpected accident. Therefore, when replacing or removing the electric power steering oil pump, make sure to perform the configuration procedure to ensure the proper EHPAS operation. |
- Make sure that there are no DTCs in the EHPAS memory after working on EHPAS related parts. If there are any codes in the memory, clear them.
- When replacing or removing the electric power steering oil pump, perform the configuration procedures. (See «ELECTRO HYDRAULIC POWER ASSIST STEERING (EHPAS) CONTROL MODULE CONFIGURATION»(ref-244338-S15061073102006092100000) ).
Power Steering Related Parts
- If any power steering fluid line has been disconnected, perform the following after installation of the power steering components. (See «AIR BLEEDING»(ref-244338-S24106460152006092100000) ). (See «POWER STEERING FLUID INSPECTION»(ref-244338-S39915782232006092100000) ). Power steering fluid amount inspection Power steering fluid leakage inspection Air bleeding Power steering fluid ATF (M-III, or equivalent (e.g. Dexron(R)II))
