Home/Lexus/LX/Lexus LX J80 (1995-1997)/Repair manual/Mechanical/Reassembly & Installation: Overview

Contents

Wiring diagrams Section: Mechanical

Engine Identification

Model Year Identification

Valve Clearance Adjustment

Removal & Installation

Fuel Pressure Release

Cylinder Head & Manifolds

Removal (Timing Chain Cover Installed)

Removal (Timing Chain Cover Removed)

Cylinder Head

Valve Springs

Valve Stem Oil Seals

Valve Guides

Valve Seat

Valves

Valve Seat Correction Angles

Valve Lifters

Piston & Rod Assembly

Fitting Pistons

Piston Rings

Rod Bearings

Crankshaft & Main Bearings

Thrust Bearing

Cylinder Block

Engine Lubricating System

Crankcase Capacity

Oil Pressure

Oil Pump

Removal & Disassembly

Torque Specifications

General Engine Specifications

Crankshaft, Main Bearings & Connecting Rod Bearings Specifications

Connecting Rods Specifications

Pistons, Piston Pins & Piston Rings Specifications

Cylinder Block Specifications

Engine Valves & Valve Springs Specifications

Cylinder Head Specifications

Camshaft Specifications

Valve Lifters Specifications

All sections

Reassembly & Installation: Overview Lexus LX J80

Mechanical 1 illustration

To reassemble, reverse disassembly procedure. Use NEW gaskets. Tighten oil pump relief valve plug to specification. See «TORQUE SPECIFICATIONS»(ref-49416-S15026808592001011500000) .
If installing crankshaft front seal, apply grease to seal lip of NEW seal. Using hammer, Handle (SST 09316-00011) and Seal Installer (SST 09316-00051), install seal until seal surface is even with timing chain cover.
To install, reverse removal procedure. Ensure proper procedures are used when installing timing chain cover and cylinder head. See «CYLINDER HEAD»(ref-49416-S20264278112001011500000) table and TIMING CHAIN under REMOVAL & INSTALLATION.

Scheme 44

Scheme 44

Scheme 44