PROCEDURE
- POWER WINDOW CONTROL SYSTEM Initialize the power window regulator motor assemblies. Refer to «INITIALIZATION»(ref-396754-S05531865522011050900000) . Check that the power windows operate normally by opening and closing the windows. OK The power windows operate normally. NG --> REPLACE POWER WINDOW REGULATOR MOTOR OK: Go to next step
- CHECK WHETHER PARTS HAVE BEEN INSTALLED CORRECTLY Power window components are installed correctly. OK Power windows components are installed correctly. HINT: When the power window components are installed correctly, the problem has been caused by battery disconnection while the engine switch is on (IG), improper installation of the power window components or the motor being overheated. NG --> INSTALL PARTS CORRECTLY OK --> END
- CHECK DTC OUTPUT Turn the engine switch off. Wait for at least 10 seconds, and then turn the engine switch on (IG). Check whether the DTC output recurs. Result Display (DTC Output) Proceed to B2313 A No output B B --> END A: Go to next step
- INITIALIZE SYSTEM (POWER WINDOW CONTROL SYSTEM) Turn the engine switch on (IG) and initialize the power window regulator motor. Refer to «INITIALIZATION»(ref-396754-S05531865522011050900000) . Turn the engine switch off. Wait for at least 10 seconds, and then turn the engine switch on (IG). Check whether the DTC output recurs. Result Display (DTC Output) Proceed to No output A B2313 B B --> REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY A --> END