REMOVAL & INSTALLATION
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery. |
Driver side junction block is located behind lower instrument panel knee bolster on driver side of instrument panel. see scheme 2 Removal and installation procedures are not available from manufacturer.
Door ECUs are mounted on bottom side of driver and front passenger power window/door lock switches. Using a screwdriver with tape applied to tip, gently pry at identified points of power window/door lock switch and release retainers. Disconnect electrical connector and remove switch. (Scheme 11) To install, reverse removal procedure.
Scheme 11
Disconnect negative battery cable. Theft deterrent ECU is located behind glove box. see scheme 2 Remove glove box to gain access to theft deterrent ECU. Further information is unavailable from manufacturer.