Basic Troubleshooting: Overview Kia Spectra I рестайлинг 2

1. Bring Vehicle to Workshop
2. Analyze Customer's Problem Ask the customer about the conditions and environment relative to the issue (Use CUSTOMER PROBLEM ANALYSIS SHEET).
3. Verify Symptom, and then Check DTC and Freeze Frame Data Connect Hi-Scan (Pro) to Diagnostic Link Connector (DLC). Record the DTC and freeze frame data. NOTE: To erase DTC and freeze frame data, refer to Step 5 .
4. Confirm the Inspection Procedure for the System or Part Using the SYMPTOM TROUBLESHOOTING GUIDE CHART, choose the correct inspection procedure for the system or part to be checked.
5. Erase the DTC and Freeze Frame Data WARNING: NEVER erase DTC and freeze frame data before completing Step 2 MIL/DTC in "CUSTOMER PROBLEM ANALYSIS SHEET".
6. Inspect Vehicle Visually Go to Step 11 , if you recognize the problem.
7. Recreate (Simulate) Symptoms of the DTC Try to recreate or simulate the symptoms and conditions of the malfunction as described by customer. If DTC(s) is/are displayed, simulate the condition according to troubleshooting procedure for the DTC.
8. Confirm Symptoms of Problem If DTC(s) is/are not displayed, go to Step 9. If DTC(s) is/are displayed, go to Step 11 .
9. Recreate (Simulate) Symptom Try to recreate or simulate the condition of the malfunction as described by the customer.
10. Check the DTC If DTC(s) does(do) not occur, refer to INTERMITTENT PROBLEM PROCEDURE in BASIC INSPECTION PROCEDURE. If DTC(s) occur(s), go to Step 11.
11. Perform troubleshooting procedure for DTC
12. Adjust or repair the vehicle
13. Confirmation test
14. END

Scheme 18

See also:
• DTC TROUBLESHOOTING PROCEDURES