Home ReviewsRefund
Home/Kia/Optima/Kia Optima III (2010-2013)/Repair manual/Door Locks & Anti-Theft Systems/Smart Key Code Saving Diagnosis - Except Hev: Other
Contents Wiring diagrams Section: Door Locks & Anti-Theft Systems All sections

Smart Key Code Saving Diagnosis - Except Hev: Other Kia Optima III

Door Locks & Anti-Theft Systems 4 illustrations ~381 words

Verification Of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 346

Scheme 346: Component Location
Scheme 346: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 347

Scheme 347: Component Location
Scheme 347: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 348

Scheme 348: Component Location
Scheme 348: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 349

Scheme 349: Component Location
Scheme 349: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTCs)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

More articles — Smart Key Code Saving Diagnosis - Except Hev