Home ReviewsRefund
Home/Kia/Optima/Kia Optima III (2010-2013)/Repair manual/Door Locks & Anti-Theft Systems/Smart Key Code Saving (Button) Diagnosis - Hev: Other
Contents Wiring diagrams Section: Door Locks & Anti-Theft Systems All sections

Smart Key Code Saving (Button) Diagnosis - Hev: Other Kia Optima III

Door Locks & Anti-Theft Systems 4 illustrations ~381 words

Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTC)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 632

Scheme 632: Component Location
Scheme 632: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTC)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 633

Scheme 633: Component Location
Scheme 633: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTC)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 634

Scheme 634: Component Location
Scheme 634: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTC)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

Scheme 635

Scheme 635: Component Location
Scheme 635: Component Location

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and check "No. of Key learnt, PCM status and Smartkey PCM status.
  2. Select "Diagnostic Trouble Codes (DTC)" mode and then clear DTC.
  3. Operate the vehicle within the enable condition and monitor the DTC on the GDS.
  4. Are any DTCs present? YES Go to the applicable troubleshooting procedure. NO System is performing to specification at this time.

More articles — Smart Key Code Saving (Button) Diagnosis - Hev