The camshafts consist of powdered metal steel lobes which are sinter-bonded to a steel tube. Four bearing journals are machined into the camshaft. Camshaft end play is controlled by two thrust walls that border the nose piece journal.
Contents
Wiring diagrams Section: Mechanical- Description: Overview
- Description
- Description: Removal & Installation
- Description: Diagnosis
- Description: Other
- Chemical Test Method
- Chemical Test Method: Overview
- Chemical Test Method: Diagnosis
- Chemical Test Method: Removal & Installation
- Chemical Test Method: Other
- Engine Oil Change: Overview
- Engine Oil Change: Diagnosis
- Engine Oil Change: Removal & Installation
- Engine Oil Change: Overhaul
- Engine Oil Change: Other
- A/c Compressor
- Abbreviations
- Accessories Control Systems
- Accessory Drive Belts
- Airbag
- Antenna Systems
- Anti-Lock/traction Control
- Automatic HVAC System
- Automatic Trans
- Axle Shafts
- Basic Trouble Shooting
- Blowers, Superchargers & Turbochargers
- Body Electrical
- Brakes
- Cabin Air Filter
- Charging System
- Check Lists
- Clutches Manual & Hydraulic
- Communication Devices
- Cruise Control Systems
- Diagnostic Connector Locations
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- DTC Index
- Electrical
- Electrical Component Locations
- Emission Applications
- Engine
- Engine Performance
- Exhaust
- Exterior Lights
- Frames, Subframes & Crossmembers
- Fuel System
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- Heated Glass/defoggers
- Horns
- Identification
- Ignition System
- Interior/illumination Lights
- Manual & Power Steering
- Manual Trans
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Mode 6
- Oem General Information
- Reset Procedures
- Seats
- Specifications
- Starter
- Steering
- Sun Roof/t-Top/convertible Top
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Traction Control Disable
- Transfer Case
- Transmission
- Warning System
- Wheel & Tire System
- Windows
- Wiper/washer Systems