Climate Control: Removal & Installation Jaguar XF I

REMOVAL

Note. Removal steps in this procedure may contain installation details.

1. Refer to «Exterior Mirror Cover»(ref-568418) information.
2. See figure.
3. See figure.
4. See figure.
5. See figure.

INSTALLATION

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

Scheme 1

Scheme 2

1. Refer to «Battery Disconnect and Connect»(ref-568400-S03532047432013072200000) information.
2. See figure.
3. See figure.

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

Scheme 3

1. Refer to «Battery Disconnect and Connect»(ref-568400-S03532047432013072200000) information.
2. See figure.
3. Torque: 1.3 Nm.

1. To install, reverse the removal procedure.

Note. The center registers must be open before carrying out this procedure. To achieve this set the registers to 'Always Open' using the climate settings tab on the information and entertainment display. If the registers are set to 'Automatic' mode (rotating with ignition on/off) and one or more are disconnected during an ignition cycle, a vehicle battery reset may be required to reconnect the affected registers to the LIN BUS.

Note. Removal steps in this procedure may contain installation details.

Scheme 4

Scheme 5

Scheme 6

1. Set the registers to 'Always Open', using the information and entertainment display.
2. See «Passenger Side Register»(ref-568412-S20834398022013072200000) .
3. Fully extend and lower the steering column for access.
4. See figure.
5. See figure.
6. See figure.
7. See figure.

1. To install, reverse the removal procedure.
2. Return the registers to their original setting - 'Automatic' - using the information and entertainment display.

Note. Removal steps in this procedure may contain installation details.

Note. RHD illustration shown, LHD is similar.

Scheme 7

Scheme 8

Scheme 9

Scheme 10

1. Refer to «Battery Disconnect and Connect»(ref-568400-S03532047432013072200000) information.
2. Raise and support the vehicle.
3. Refer to «Instrument Panel Console»(ref-568419-S06047680652013072200000) information.
4. See figure.
5. Torque: 9 Nm.
6. Torque: 9 Nm.
7. See figure.

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

Scheme 11

1. Refer to «Battery Disconnect and Connect»(ref-568400-S03532047432013072200000) information.
2. Refer to «Instrument Panel Console»(ref-568419) information.
3. Torque: 1.3 nm.

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

Scheme 12

1. Refer to «Battery Disconnect and Connect»(ref-568400-S03532047432013072200000) information.
2. Refer to «Instrument Panel Console»(ref-568419) information.
3. Torque: 1.3 Nm.

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

Scheme 13

Scheme 14

Scheme 15

1. Raise and support the vehicle.
2. Refer to «Air Conditioning (A/C) System Recovery, Evacuation and Charging»(ref-568393-S34540577132013072200000) information.
3. Refer to «Radiator Splash Shield»(ref-568406-S39527244732013072200000) information.
4. See figure.
5. Torque: 12 Nm.
6. See figure.

1. To install, reverse the removal procedure.

Note. If the registers are set to 'Automatic' mode and one or more are disconnected during an ignition cycle, a vehicle battery reset may be required to reconnect the affected registers to the LIN BUS.

Note. Removal steps in this procedure may contain installation details.

Scheme 16

Scheme 17

Scheme 18

Scheme 19

Scheme 20

1. See figure.
2. See figure.
3. See figure.
4. Fully extend and lower the steering column for access.
5. See figure.
6. See figure.
7. See figure.
8. See figure.

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

All vehicles

Scheme 21

Scheme 22

Scheme 23

Scheme 24

Scheme 25

Scheme 26

1. Refer to «Battery Disconnect and Connect»(ref-568400-S03532047432013072200000) information.
2. See «Heater Core and Evaporator Core Housing»(ref-568412-S20808139432013072200000) .
3. See «Thermostatic Expansion Valve»(ref-568412-S07363399662013072200000) .
4. Torque: 1.3 Nm.
5. Torque: 1.3 Nm.
6. See figure.
7. See figure.
8. Torque: 1.3 Nm.
9. See figure.
10. See figure.

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

Scheme 27

Scheme 28

1. Remove both floor console side trim panels. Refer to «Floor Console Side Trim Panel»(ref-568419-S03729311372013072200000) information.
2. See figure.
3. See figure.
4. Remove the 2 clips.

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

Scheme 29

1. Refer to «Battery Disconnect and Connect»(ref-568400-S03532047432013072200000) information.
2. See «Climate Control Assembly»(ref-568412-S26723956182013072200000) . .
3. Torque: 1.3 Nm.

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

Note. Some variation in the illustrations may occur, but the essential information is always correct.

All vehicles

Scheme 30

Scheme 31

Scheme 32

Scheme 33

1. Refer to «Battery Disconnect and Connect»(ref-568400-S03532047432013072200000) information.
2. See «Heater Core and Evaporator Core Housing»(ref-568412-S20808139432013072200000) .
3. Torque: 1.3 Nm.
4. Torque: 1.3 Nm.
5. See figure.
6. Torque: 1.3 Nm.
7. See figure.
8. See figure.

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

Scheme 34

Scheme 35

Scheme 36

Scheme 37

Scheme 38

Scheme 39

1. Refer to «Battery Disconnect and Connect»(ref-568400-S03532047432013072200000) information.
2. Raise and support the vehicle.
3. See «Climate Control Assembly»(ref-568412-S28897978582013072200000) .
4. Torque: 1.3 Nm.
5. Torque: 1.3 Nm.
6. See figure.
7. See figure.
8. Torque: 2.4 Nm.
9. Torque: 2.4 Nm.

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

Scheme 40

Scheme 41

Scheme 42

1. Refer to «Battery Disconnect and Connect»(ref-568400-S03532047432013072200000) information.
2. See «Center Registers»(ref-568412-S32626699962013072200000) .
3. See figure.
4. See figure.
5. See figure.
6. See figure.

Scheme 43

1. To install, reverse the removal procedure.
2. Position the locating peg.

Note. Removal steps in this procedure may contain installation details.

Scheme 44

1. Refer to «Glove Compartment»(ref-568419-S21948879032013072200000) information.
2. See figure.

1. To install, reverse the removal procedure.

Note. If the registers are set to 'Automatic' mode and one or more are disconnected during an ignition cycle, a vehicle battery reset may be required to reconnect the affected registers to the LIN BUS.

Note. Removal steps in this procedure may contain installation details.

Scheme 45

Scheme 46

Scheme 47

Scheme 48

Scheme 49

1. See figure.
2. See figure.
3. See figure.
4. See figure.
5. See figure.
6. Install the clips into the instrument panel.
7. See figure.
8. See figure.
9. See figure.

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

Scheme 50

Scheme 51

Scheme 52

1. See figure.
2. See figure.
3. See figure.

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

Scheme 53

1. Refer to «Battery Disconnect and Connect»(ref-568400-S03532047432013072200000) information.
2. Refer to «Glove Compartment»(ref-568419-S21948879032013072200000) information.
3. See figure.

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

Scheme 54

Scheme 55

1. Refer to «Battery Disconnect and Connect»(ref-568400-S03532047432013072200000) information.
2. See figure.
3. See figure.
4. Torque: 2 Nm.

Scheme 56

1. To install, reverse the removal procedure.

Note. Removal steps in this procedure may contain installation details.

Note. Some variation in the illustrations may occur, but the essential information is always correct.

Scheme 57

Scheme 58

Scheme 59

Scheme 60

1. Refer to «Battery Disconnect and Connect»(ref-568400-S03532047432013072200000) information.
2. See «Climate Control Assembly»(ref-568412-S28897978582013072200000) .
3. Torque: 1.3
4. Torque: 1.3 Nm.
5. Torque: 5.3 Nm.
6. Torque: 3.5 Nm.

1. To install, reverse the removal procedure.