Home/Isuzu/Amigo/Isuzu Amigo II (1998-2000)/Repair manual/Removal & Installation/Engine Controls - Remove/install/overhaul: Specifications
Contents Wiring diagrams Section: Removal & Installation All sections

Engine Controls - Remove/install/overhaul: Specifications Isuzu Amigo II

TORQUE SPECIFICATIONS

ApplicationFt. Lbs. (N.m)
2.2L - Amigo, Rodeo & Passport
Crankshaft Pulley Bolts14 (20)
Fuel Rail Bolts19 (14)
Oxygen Sensor40 (55)
2.2L - Hombre & 4.3L
Accelerator Cable Bracket Bolts18 (25)
Accelerator Cable Bracket Nut22 (30)
ECT Sensor18 (25)
EGR Valve Assembly
2.2L17 (24)
4.3L18 (25)
Fuel Tank Retaining Strap Bolts26 (45)
Knock Sensor14 (19)
Oxygen Sensor30 (41)
Upper Intake Manifold Nuts & Bolts22 (30)
3.2 & 3.5L
Coolant Pipe Rear Mounting Bolt12 (16)
DIS Assembly Retaining Bolts14 (19)
EGR Valve Assembly10 (14)
Engine Coolant Temperature Sensor22 (30)
Front Drive Shaft Yoke46 (62)
Fuel Tank Drain Plug14 (20)
Fuel Tank Retaining Bolts27 (36)
Knock Sensor (3.5L)15 (20)
Lower Intake Manifold Nuts & Bolts15 (20)
Oxygen Sensor40 (55)
Right Exhaust Shield27 (37)
Throttle Body Bolts10 (14)
Throttle Body Chamber Nuts & Bolts17 (24)
Upper Intake Manifold Nuts & Bolts15 (20)
Vehicle Speed Sensor12 (16)
INCH Lbs. (N.m)
2.2L Hombre & 4.3L
Crankshaft Position Sensor Bolts72 (8)
Idle Air Control Valve27 (3)
Ignition Coil Assembly Attaching Bolts12 (1.3)
Ignition Coil(s) Retaining Screws40 (4.5)
Injector Retainer Bracket Attaching Screws31 (3.5)
Throttle Position Sensor Attaching Screws27 (3)
2.2L Amigo, Rodeo & Passport
Camshaft Position Sensor Bolts72 (8)
Crankshaft Position Sensor Bolts72 (8)
Idle Air Control Valve9 (1)
3.2L & 3.5L
Camshaft Position Sensor Bolts78 (9)
Crankshaft Position Sensor Bolts78 (9)
Fuel Pressure Regulator Attaching Screw
3.2L60 (6.5)
3.5L26 (3)
Fuel Rail Bolts75 (8)
Idle Air Control Valve9 (1)
Knock Sensor (3.2L)62 (6.7)

TORQUE SPECIFICATIONS

See also:
ADJUSTMENTS