LUBRICATION SPECIFICATIONS
| Material | Condition | Specification |
|---|---|---|
| Engine Oil (1) | Ambient Temperature Above -13°F (-25°C) To 100°F (38°C) | SAE 10W-30 |
| Engine Oil (1) | Ambient Temperature Less Than -13°F (-25°C) To 100°F (38°C) | SAE 5W-30 |
| Engine Oil (1) | Ambient Temperature Above 5°F (-15°C) To Over 100°F (38°C) | SAE 15W-40, SAE 20W-40, SAE 20W-50 |
| Engine Coolant | All | 50/50 Mixture Distilled Water Ethylene Glycol |
| Brake Fluid | All | DOT 3 |
| Manual Transmission Oil | Ambient Temperature Above 90°F (32°C) | SAE 15W-40, SAE 20W-40, SAE 20W-50 |
| Manual Transmission Oil | Other Areas | SAE 5W-30 |
| Transfer Case Oil | All | SAE 5W-30 SF Engine Oil |
| Front Axle Oil | Ambient Temperature Below 50°F (10°C) | Hypoid Gear Oil API Service GL-5 SAE 75W-90 |
| Front Axle Oil | Ambient Temperature From 0°F (-18°C) To 90°F ( 32°C) | SAE 75W-90 |
| Front Axle Oil | Ambient Temperature Above 50°F (10°C) Consistantly | SAE 80W-90 or SAE 80W-140 |
| Rear Axle Oil | Ambient Temperature Below 50°F (10°C) | Hypoid Gear Oil API Service GL-5 SAE 80 or SAE 80W-90 |
| Rear Axle Oil | Ambient Temperature From 0°F (-18°C) To 90°F ( 32°C) | SAE 90 or SAE 80W-90 |
| Rear Axle Oil | Ambient Temperature Above 50°F (10°C) Consistantly | SAE 140 |
| Shift-on-the Fly System | All | Hypoid Gear Oil API Service GL-5 SAE 75W-90 |
| Front & Rear Propeller Shaft | 4WD | Molybdenum Disulfite Type Grease |
| Multi- Purpose Grease | All | NLGI No. 1 or 2 (Lithium base) |
| A/C Refrigerant | All | R-134a |
| A/C Refrigerant Oil | All | ND Oil 8 |
| (1) SAE 10W-30, energy conserving oils are preferred. Use API approved oil with the Starburst Symbol. | ||
| (1) | SAE 10W-30, energy conserving oils are preferred. Use API approved oil with the Starburst Symbol. |
LUBRICATION SPECIFICATIONS
FLUID CAPACITIES
| Item | Condition | Specification (1) |
|---|---|---|
| Engine Oil | 3.2L: Drained, With Filter | 5.0 Qts. (4.7L) |
| Engine Oil | 3.2L: Drained, W/O Filter | 4.2 Qts. (4.0L) |
| Engine Oil | 2.2L: Drained, With Filter | 4.8 Qts. (4.5L) |
| Engine Oil | 2.2L: Drained, W/O Filter | 4.4 Qts. (4.2L) |
| Engine Coolant | 3.2L M\T: Drained | 11.2 Qts. (10.6L) |
| Engine Coolant | 3.2L A/T: Drained | 11.1 Qts. (10.5L) |
| Engine Coolant | 2.2L: Drained | 7.3 Qts. (6.9L) |
| Manual Transmission | 4WD: Capacity | 3.1 Qts. (2.95L) |
| Manual Transmission | 2WD: Capacity | 2.25 Qts. (2.13L) |
| Transfer Case Oil | Capacity | 1.5 Qts. (1.45L) |
| Rear Axle Oil | Capacity | 1.87 Qts. (1.77L) |
| Front Axle | 3.2L: Capacity | 1.33 Qts. (1.25L) |
| Front Axle | 2.2L: Capacity | 1.12 Qts. (1.05L) |
| Shift on the Fly System | Capacity | 0.13 Qts. (0.12L) |
| Fuel Tank | Capacity | 17.7 Gal. (67.0L) |
| (1) Capacities are recommended or calculated levels. Always use dipstick (if available) to measure level. | ||
| (1) | Capacities are recommended or calculated levels. Always use dipstick (if available) to measure level. |
FLUID CAPACITIES
WHEEL & TIRE SPECIFICATIONS
Wheel and tire information can be found on the Gross Vehicle Weight Rating (GVWR) decal on the trailing edge of the driver's door.
WHEEL TIGHTENING
Tighten wheel lug nuts to 87 ft. lbs. (118 N.m).
BATTERY SPECIFICATIONS
| CAUTION | When battery is disconnected, vehicles equipped with computers may lose memory data. When battery power is restored, driveability problems may exist on some vehicles. These vehicles may require a relearn procedure. See COMPUTER RELEARN PROCEDURES article in the GENERAL INFORMATION Section. |
If battery is replaced, new battery should be of the same group number as shown on the original battery's label.