Home/Infiniti/M45/Infiniti M45 II (2002-2004)/Repair manual/Automatic Transaxle/Vehicle Does Not Decelerate By Engine Brake
Contents Wiring diagrams Section: Automatic Transaxle All sections

Vehicle Does Not Decelerate By Engine Brake Infiniti M45 II

Automatic Transaxle 4 illustrations ~339 words

Vehicle Does Not Decelerate By Engine Brake

SYMPTOM

No engine brake is applied when the gear is shifted from the D2 to D1.

Scheme 614

Scheme 614: DIAGNOSTIC PROCEDURE

Scheme 615

Scheme 615

Scheme 616

Scheme 616
  1. CHECK SELF-DIAGNOSTIC RESULTS Execute self-diagnosis. Do the self-diagnostic results indicate PNP switch, ATF pressure switch 5? YES >> Check the malfunctioning system. Refer to " «DTC P0705: PARK/NEUTRAL POSITION SWITCH»(ref-181179-S40613915482005080100000) ", " «DTC P1845: ATF PRESSURE SWITCH 5»(ref-181179-S17094668002005080100000) ". NO >> GO TO 2.
  2. CHECK A/T FLUID LEVEL Check A/T fluid level again. Refer to " «CHECKING A/T FLUID»(ref-181179-S06699314042005080100000) ". OK or NG OK >> GO TO 3. NG >> Refill ATF.
  3. CHECK CONTROL LINKAGE Check the control linkage. Refer to " «CHECKING OF A/T POSITION»(ref-181179-S33242700162005080100000) ". OK or NG OK >> GO TO 4. NG >> Adjust control linkage. Refer to " «ADJUSTMENT OF A/T POSITION»(ref-181179-S34923439392005080100000) ".
  4. MANUAL MODE SWITCH Check the manual mode switch. Refer to " «DTC P1815: MANUAL MODE SWITCH»(ref-181179-S09340547462005080100000) ". OK or NG OK >> GO TO 5. NG >> Repair or replace damaged parts.
  5. CHECK A/T FLUID CONDITION Remove oil pan. Refer to " «Control Valve Assembly»(ref-181179-S41631355262005080100000) ". Check A/T fluid condition. OK or NG OK >> GO TO 6. NG >> GO TO 9 .
  6. DETECT MALFUNCTIONING ITEM Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to " «SYMPTOM CHART»(ref-181179-S42570461462005080100000) ". OK or NG OK >> GO TO 7. NG >> Repair or replace damaged parts.
  7. CHECK SYMPTOM Check again. OK or NG OK >> INSPECTION END NG >> GO TO 8.
  8. PERFORM TCM INSPECTION Perform TCM input/output signal inspection. If NG, recheck TCM pin terminals for damage or loose connection with harness connector. OK or NG OK >> INSPECTION END NG >> Repair or replace damaged parts.
  9. DETECT MALFUNCTIONING ITEM Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to " «SYMPTOM CHART»(ref-181179-S42570461462005080100000) ". OK or NG OK >> GO TO 7 . NG >> Repair or replace damaged parts.

Scheme 617

Scheme 617: Control Device Removal and Installation