- Place heater controls to maximum heat setting. Fill cooling system using a 50/50 mixture of coolant and water to bottom of filler neck. Loosen bleed bolt located in thermostat housing. Tighten bleed bolt to specification when coolant flows from bleed bolt in steady stream without bubbles. See «TORQUE SPECIFICATIONS»(ref-49294-S25340527252001011500000) .
- With radiator cap off, start and operate engine until cooling fan comes on at least twice. Stop engine. Add coolant as necessary to fill radiator to bottom of filler neck. Install radiator cap, start engine and check for leaks.
| CAUTION | DO NOT allow coolant to spill on electrical parts or vehicle paint. If coolant spills, rinse with water immediately. |
Note. Before disconnecting battery or removing radio fuse, obtain anti-theft code for radio. After battery is reconnected, CODE will appear on radio display. Enter 5-digit code to restore radio operation. If code is entered incorrectly 3 times, leave radio on at least one hour, then enter code correctly. Anytime radio power is lost, pre-selected radio stations will have to be set. For more information, see owner's manual.